 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] meshing of non equilateral hexahedron |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 1, 2013, 06:50
|
meshing of non equilateral hexahedron
|
#1 |
|
Member
Stephan Langenberg
Join Date: Sep 2011
Location: Germany
Posts: 73
Rep Power: 14  |
For my Fluent simulation I need a mesh with cubic elements. Using the cut cell method a mesh was established and manipulated with the adapt function in Fluent (figure).
- If possible I would like to coursen the hexahedron in one direction (but the other two should stay as they are). Make a isometric cube to a cuboid. Does anyone know if this is possible in the Ansys Meshing Function? I reogniced nothing about this in the Users Guide. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
| Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 05:01 |
| Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Threaded Mode
