|
[Sponsors] |
[ICEM] Detecting negative vlomume elements in ICEM |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 6, 2013, 01:31 |
Detecting negative vlomume elements in ICEM
|
#1 |
Senior Member
Henry Arrigo
Join Date: Jun 2010
Location: Italy
Posts: 100
Rep Power: 15 |
Hi everybody
What Kind of quality type should be checked in ICEM for Unstrct Mesh to find the negative volume elements? I checked Quality, Determinant, Skew and Aspect Ratio in ICEM but nothing were found. However when I import the mesh into CFX I get the negative element error. |
|
July 8, 2013, 11:21 |
|
#2 |
New Member
Adrian
Join Date: Jul 2013
Location: Dublin
Posts: 21
Rep Power: 13 |
Hi Henry,
This has been discussed in topics before. In the quality metrics graph, there's an option to display quality by volume. If you look at the histogram, you'll see that your minimum value will be zero or negative. Highlighting this bar will allow you to see where the negative volume elements; you can work from there. Last edited by adunne304; July 9, 2013 at 04:39. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
[blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |