|
[Sponsors] |
August 6, 2013, 08:22 |
Non-coinciding curve and surface edge
|
#1 |
Member
Join Date: Feb 2011
Posts: 62
Rep Power: 15 |
Dear Icem CFD users,
On the attached picture below, you can see a section of the block structured grid. The top layer is supposed to be in accordance with the lower ones. The problem is that edge of the surface (blue line) and the curve to which the edge was associated (red line) do not coincide. Is the only thing to do a geometry repair? If so, how? Because I do not know the strategy. Or am I supposed to use another software other than Icem only for geometry generation? By the way, the right side of the section belongs to a curvature, and the top surface is planar. This must be a common problem, maybe for the people who do not have the grasp of geometry repair like me, I would really appreciate even if someone gave me the title or the class of this problem, so that I can look for a remedy on this forum. Thanks in advance. Last edited by highhopes; August 6, 2013 at 08:23. Reason: Forgot to add something about the picture |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Problems with coedge curves and surfaces | tommymoose | ANSYS Meshing & Geometry | 6 | December 1, 2020 11:12 |
[ICEM] Forcing surface and curve to match | sherifkadry | ANSYS Meshing & Geometry | 0 | August 27, 2010 00:28 |
Normal - Helical Surface | m. malik | Main CFD Forum | 3 | February 3, 2006 12:56 |
solid edge problem....can you help? | cindy | Main CFD Forum | 3 | April 5, 2004 13:43 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |