|
[Sponsors] |
September 24, 2013, 20:50 |
translating ICEM mesh while copying
|
#1 |
Senior Member
Nick
Join Date: Nov 2010
Posts: 126
Rep Power: 15 |
Hi guys,
I have a 3d horizontal cylinder in a C-grid type domain. I have created hex using pre-mesh. Now I realized I should increase the domain in the span direction. So I figured I'd translate my already existing mesh with the copy option. I do that and all the parts are fine except the side planes. So naturally I get four side planes after translation. Two of them coincide (the middle ones). Each two side plane is assigned to ONE part. So I get two parts say Right and Left each of which has two planes associated with it. Is there a way I could create a new part assigned to the middle planes (the ones that coincide) so I still have one Left and one Right plane? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
Gambit problems | Althea | FLUENT | 22 | January 4, 2017 03:19 |
[ANSYS Meshing] Question about ICEM mesh output to CFX | lnk | ANSYS Meshing & Geometry | 0 | July 27, 2012 15:39 |
Boddy fitted Hexcore Mesh in ICEM Cfd | Mitch | CFX | 0 | December 29, 2008 06:07 |
ICEM clustering of mesh points and multiple edges | webhaw | CFX | 4 | July 25, 2007 16:29 |