|
[Sponsors] |
[ICEM] Tagging Faces of block or converting faces of block into surface |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 19, 2013, 10:04 |
Tagging Faces of block or converting faces of block into surface
|
#1 |
Senior Member
Ashwani
Join Date: Sep 2013
Location: Hyderabad
Posts: 154
Rep Power: 12 |
Dear all,
Is it possible to tag the faces of the blocks which are lying on the boundaries. Or, is it possible to convert the faces of the block into surfaces. So, that using create part I can name them. I need to read the mesh file zone wise. And my zones will be the blocks created. Please if any one can help. |
|
October 19, 2013, 14:49 |
|
#2 |
Senior Member
Ashwani
Join Date: Sep 2013
Location: Hyderabad
Posts: 154
Rep Power: 12 |
It feels that in earlier version of ANSYS there was some bug while writing cgns file. In ANSYS14 ICEMCFD, I am able to have a single defined surface facing two or more block faces. My code reads the cgns file properly.
But still, I have problem in having a proper interface tagging. My code is showing only 3 boundaries for some zone for the 3d cylinder meshing. I am using the 2d-3d extruding mesh tutorial shown on Youtube. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
[blockMesh] Mixer mesh - negative volume problem | jadtwo | OpenFOAM Meshing & Mesh Conversion | 2 | November 6, 2014 16:37 |
[blockMesh] FOAM FATAL ERROR: Inconsistent number of faces blockMesh::createMergeList() line 193 | Hengel | OpenFOAM Meshing & Mesh Conversion | 0 | September 15, 2010 08:34 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |