 |
 |
 |
|
|
|
[Sponsors] | ||||
May 6, 2014, 03:06
|
Meshing separate parts
|
#1 |
|
New Member
Manaswinee Patnaik
Join Date: Jan 2013
Location: India
Posts: 4
Rep Power: 13  |
HELLO,
I am meshing a compound open channel in Fluent. At the interface of main channel and flood plain I am not getting the desired structural mesh since the bed level of floodplain is higher than the main channel. Moreover the meshes inside the main channel are fully distorted and I am unable to refine the meshes near the boundary using bais option. So i want to split the edges. Here i want to know is it effective to split the edges and to mesh the geometry parts differently. Please suggest any effective way to do this. Thanks in advance. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
| Urgent help, help pl for meshing problem | Shashi | FLUENT | 8 | October 8, 2008 11:24 |
| Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
| Meshing 2 separate objects | david | Main CFD Forum | 2 | March 12, 2007 07:37 |
| Meshing a volume having two parts | IQTEDAR | FLUENT | 0 | December 25, 2002 15:58 |
Linear Mode
