 |
 |
 |
|
|
|
[Sponsors] | ||||
May 24, 2014, 17:39
|
Icem local refinement problem
|
#1 |
|
New Member
kourosh
Join Date: Aug 2013
Posts: 10
Rep Power: 12  |
Hello every one
i am trying to mesh my geometry which is a 3d cylinder as an injector in free domain and i want to do 3 level refinement inside the cylinder . the problem is when i transport the mesh to the fluent there is a problem around my cylinder like some nodes are missing like the pictures blow. i have tried some solution that i found in this forum like edit mesh- resolve refinement or check/fix mesh but none of them worked . i would appreciate any help,Thanks icem problem.jpg fluent problem.JPG fluent problem2.jpg |
|
|
|
|
|
July 3, 2014, 07:49
|
|
#2 | |
|
New Member
Du An
Join Date: Jun 2013
Posts: 2
Rep Power: 0 |
Quote:
|
||
|
|
|
||
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transient simulation not converging | skabilan | OpenFOAM Running, Solving & CFD | 14 | December 16, 2019 23:12 |
| [snappyHexMesh] Adding layers goes wrong with SnappyHexMesh | Elise | OpenFOAM Meshing & Mesh Conversion | 1 | April 22, 2013 02:32 |
| [snappyHexMesh] Weird snapping outside a refinement region | jasimpson89 | OpenFOAM Meshing & Mesh Conversion | 0 | July 29, 2012 20:46 |
| Upgraded from Karmic Koala 9.10 to Lucid Lynx10.04.3 | bookie56 | OpenFOAM Installation | 8 | August 13, 2011 04:03 |
| ICEM boundary condition problem | Martin_D | ANSYS Meshing & Geometry | 2 | February 14, 2011 10:20 |
Linear Mode
