|July 30, 2014, 01:14||
changing circle with a square at inlet in Eulerian-Eulerian
Join Date: Jul 2014
Posts: 32Rep Power: 4
I am trying to model a rectangular sieve tray
my question is that does the shape of inlet has effects on the result in an eulerian eulerian framework?
may I change an circled inlet with a squared one?
I am asking this question because the holes in my modeling are very fine(1.8 mm diameter) so the mesh must be very fine too in order to be able to mesh the circle with a pentagon (the triangle edge should be about 1 mm ) so the mesh is too much fine.
|change boundary condition, circle, eulerian multiphase model, inlet boundary condition, mesh|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Changing inlet conditions without starting again||Conflate||OpenFOAM Pre-Processing||2||April 1, 2011 07:29|
|Changing Boundary: Decreasing Inlet Velocity - Convergence Issues||VT_Bromley||FLUENT||3||February 12, 2011 10:02|
|Changing area with a random value of pressureinlet||M-Ray||FLUENT||0||May 16, 2008 02:48|
|transitional inlet boundary condition||kamp||CFX||1||June 21, 2006 11:08|
|Changing inlet mass fractions of CH4 and O2||Prateep Chatterjee||FLUENT||4||June 13, 2002 12:06|