|
[Sponsors] |
October 12, 2014, 20:08 |
joining mesh
|
#1 |
Member
zduno
Join Date: Dec 2013
Posts: 55
Rep Power: 12 |
Hello gentlemen.
I don't know how to "join" two blocks that i meshed. I am not sure how to explan this properly but when I export the mesh to the fluent i get a line (wall boundary) between top middle block and the one in the bottom. I just dont knot how to put two meshes from two blocks into one ;( thanks in advance When i simply try to merge them I get error "merge region not structured". |
|
October 13, 2014, 22:23 |
|
#2 |
Senior Member
Join Date: Mar 2014
Posts: 375
Rep Power: 13 |
easy, in ansys design modeller select the two different parts and make them a single part (select both by control key and then right click to see the option)
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
sliding mesh problem in CFX | Saima | CFX | 46 | September 11, 2021 07:38 |
Star CCM Overset Mesh Error (Rotating Turbine) | thezack | Siemens | 7 | October 12, 2016 11:14 |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |