|
[Sponsors] |
[ICEM] smooth boundary layer near sharp angles |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 15, 2014, 05:24 |
smooth boundary layer near sharp angles
|
#1 |
New Member
filippo giussani
Join Date: Sep 2014
Posts: 1
Rep Power: 0 |
hi , i have a problem with the smoothing of a boundary layer near a sharp angle . The starting mesh seems to be good but is too sharp and i think that without smoothing it the further simulation would give me some problems. as smoothing parameters i choose :
10 iterations on surface 5 iterations on volume laplace smooth on surface either on volume smooth all curves advanced options: use orthogonal distance (surface and volume) surface fitting keep periodic geometry i attach the picture of the mesh previous and further the smoothing. |
|
Tags |
boundary layer mesh, icem, sharp angles |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No-slip condition for non-resolved boundary layer in open channel banks | Lupocci | Main CFD Forum | 1 | January 17, 2013 04:11 |
Water subcooled boiling | Attesz | CFX | 7 | January 5, 2013 04:32 |
[snappyHexMesh] Boundary layer in a pipe | Clementhuon | OpenFOAM Meshing & Mesh Conversion | 6 | March 12, 2012 13:41 |
Convective Heat Transfer - Heat Exchanger | Mark | CFX | 6 | November 15, 2004 16:55 |
New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 07:18 |