 |
 |
 |
|
|
|
[Sponsors] | ||||
April 24, 2014, 15:15
|
Meshing a Cylinder
|
#1 |
|
New Member
anup radhakrishnan
Join Date: Jan 2014
Posts: 24
Rep Power: 12  |
Hi,
Can any one please advise on how to create a structured mesh for a cylinder in Ansys? The problem I am facing is at the top and bottom faces. I am trying to simulate the flow past a finite 3D cylinder with a volume of water above it. I have meshed this volume as a structured mesh corresponding to the fluid domain around the cylinder. The domain around the cylinder is modelled as a block with a hole in it. This necessitates the addition of a cylinder above the hole to capture the mesh effectively. Is this the right approach to meshing these kind of problems? I have attached a few pics of the same. thanks, Anup bottom domain.jpg top domain.jpg |
|
|
|
|
|
April 28, 2014, 11:58
|
|
#3 |
|
Super Moderator
Alex
Join Date: Jun 2012
Location: Germany
Posts: 3,399
Rep Power: 46 |
If you want a pure hex mesh, you can further divide the cylindrical volume above the cylinder to get volume elements with hexahedral shape.
top domain.jpg |
|
|
|
|
|
|
December 9, 2014, 12:32
|
|
#4 |
|
New Member
Scott Telford
Join Date: Dec 2014
Posts: 1
Rep Power: 0 |
Hi,
What method did you use for this? |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Meshing of 2D cylinder / number of nodes | leonidassr | ANSYS Meshing & Geometry | 4 | September 23, 2013 06:08 |
| [GAMBIT] structured Meshing cylinder and airfoil NASA 0012 | wesam | ANSYS Meshing & Geometry | 2 | October 1, 2012 14:33 |
| [blockMesh] meshing a cylinder | Nico A. | OpenFOAM Meshing & Mesh Conversion | 0 | April 7, 2011 11:09 |
| [snappyHexMesh] SnappyHexMesh Meshing inside a cylinder | nammari | OpenFOAM Meshing & Mesh Conversion | 5 | March 11, 2011 19:49 |
| Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
Linear Mode
