Home > Forums > Software User Forums > ANSYS > ANSYS Meshing & Geometry

[ANSYS Meshing] Non-uniform meshing in ANSYS fluent

Updated Threads

Reply

Search this Thread

January 6, 2015, 01:34	Non-uniform meshing in ANSYS fluent	#1
natty_celo New Member anonymous Join Date: Jan 2015 Posts: 1 Rep Power: 0	I want to mesh cylinder but meshing is non-uniform along its length. Its little finer near the ends. What should I do to make it uniform?

January 12, 2015, 23:59		#2
Kapi Senior Member Join Date: Apr 2014 Location: Melbourne Posts: 584 Rep Power: 14	use "sizing" feature in mesh

Reply

Tags

meshing in fluent, non-uniform meshing, uniform meshing in fluent

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Strange high velocity in centrifugal pump simulation	huangxianbei	OpenFOAM Running, Solving & CFD	26	August 15, 2014 02:27
pressure and velocity in OpenFoam is smaller than Fluent	mechy	OpenFOAM	4	September 18, 2013 16:19
rhoSimpleFoam	claco	OpenFOAM	7	April 20, 2010 04:32
RasInterFoam STRANGE RESULTS AT BOUNDARY	kumar2	OpenFOAM Running, Solving & CFD	8	March 24, 2008 18:38
FLUENT to ANSYS Temperature Mapping Procedure	schreiberc1	FLUENT	0	June 29, 2006 13:50

All times are GMT -4. The time now is 12:19.