[DesignModeler] Generating airfoil using 3d curve function available on design modeler

Patrick_18 · December 24, 2018, 11:55

I was followed same procedure as given in tutorial but
I can't produce my geometry . Here I attached txt file of coordinate and error shown while attempting 3d curve function on design modeler.
Please provide answer as early as possible

AtoHM · January 3, 2019, 03:09

I invested 20sec to check, that your first coordinate lies exactly at the position of your last coordinate, which is exactly the error you get.

lgn_aero · January 8, 2019, 10:33

Yup, but the wing trailing edge must be closed. Design Modeler need to be improved in this aspect I think......

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Ffd_control_point_2d	feiyi	SU2	4	September 30, 2019 12:42
Doxygen documentation	Tanay	OpenFOAM Installation	9	September 23, 2011 11:40
[blockMesh] BlockMesh FOAM warning	gaottino	OpenFOAM Meshing & Mesh Conversion	7	July 19, 2010 14:11
Problem with rhoSimpleFoam	matteo_gautero	OpenFOAM Running, Solving & CFD	0	February 28, 2008 06:51
Info: Short Course On Thermal Design of Electronic Equipment	Arnold Free	Main CFD Forum	0	August 10, 1999 10:18

January 3, 2019, 03:09		#2
AtoHM Senior Member M Join Date: Dec 2017 Posts: 645 Rep Power: 12	I invested 20sec to check, that your first coordinate lies exactly at the position of your last coordinate, which is exactly the error you get.

January 8, 2019, 10:33		#3
lgn_aero New Member N/A Join Date: Mar 2013 Posts: 17 Rep Power: 13	Yup, but the wing trailing edge must be closed. Design Modeler need to be improved in this aspect I think......