|
[Sponsors] |
April 20, 2015, 21:38 |
boundary layer meshing error in ICEM
|
#1 |
New Member
Madan Mohan
Join Date: Jan 2015
Posts: 8
Rep Power: 11 |
Hi,
I m doing a flow simulation in a turbine stator. I'm using ICEM for meshing the regions. For solving the boundary layer near to the blade surface I have used prism layers around the pressure and suction surfaces. But the prism meshes are generated on both sides of the blade (i.e) on the fluid and the solid regions. How to avoid meshing the solid part of the blade which does not require boundary layer resolution? Please kindly address this issue anyone? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
GAMBIT meshing problem for boundary layer | Falah | FLUENT | 2 | November 30, 2020 14:16 |
Wind turbine simulation | Saturn | CFX | 58 | July 3, 2020 01:13 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
[GAMBIT] 3D Boundary Layer Laminar and Turbulent meshing | Harald D | ANSYS Meshing & Geometry | 1 | July 7, 2009 06:20 |
Boundary Layer Meshing of a nosecone | Chris | FLUENT | 1 | March 15, 2005 12:42 |