|
[Sponsors] |
[ICEM] Mesh extending through block (undesired) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 8, 2015, 08:30 |
Mesh extending through block (undesired)
|
#1 |
Member
Join Date: Dec 2012
Posts: 81
Rep Power: 13 |
Hi there,
I face the following problem in ICEM: I would like to mesh the geometry on the picture by an O-Grid on every sub-section of the wing. However, when displaying my Pre-Mesh for the first section the mesh extends through the block into the next section (in a way I do not want). My question is: How can that be? And how can I fix that? Thank you very much in advance for the help!! |
|
May 9, 2015, 07:44 |
|
#2 | |
Senior Member
|
Quote:
Attach a picture of the blocking without the blocks just edges. And may be it will be easier to see what's wrong. |
||
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] ICE Mesh in ICEM - Block merge | AA29 | ANSYS Meshing & Geometry | 19 | March 23, 2018 06:08 |
[ICEM] Problem making structured mesh on a surface | froztbear | ANSYS Meshing & Geometry | 4 | November 10, 2011 08:52 |
[ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
[Commercial meshers] Icem Mesh to Foam | jphandrigan | OpenFOAM Meshing & Mesh Conversion | 4 | March 9, 2010 02:58 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |