[ICEM] Overset mesh

cinclus · February 3, 2015, 20:08

Dear all,

I'm just wondering whether it is possible to build an overset grid with ICEM given that most of my research led to STAR-CCM+ which I have never used before.

In case ICEM does not allow this approach is it possible to export the background mesh I have already created in ICEM to STAR-CCM+?

Ollie West · June 9, 2015, 11:54

Hi cinclus,

It is possible to export meshes generated in ICEM to Star-CCM+. However with overset meshing you will have to be very careful that the boundary between the background mesh and overset mesh contain cells of approximately the same size.

This could make generating efficient grids with inflation control in certain regions a problem if the overset were to move near them.

Hope this helps.

Ollie.

February 3, 2015, 20:08	Overset mesh	#1
cinclus New Member Umberto Join Date: May 2014 Posts: 22 Rep Power: 11	Dear all, I'm just wondering whether it is possible to build an overset grid with ICEM given that most of my research led to STAR-CCM+ which I have never used before. In case ICEM does not allow this approach is it possible to export the background mesh I have already created in ICEM to STAR-CCM+?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[snappyHexMesh] problems generating clean mesh	Christian_tt	OpenFOAM Meshing & Mesh Conversion	2	June 20, 2019 05:39
[ICEM] surface mesh merging problem	everest	ANSYS Meshing & Geometry	44	April 14, 2016 06:41
Overset mesh error	Caterpillar85	STAR-CCM+	2	February 12, 2013 05:54
[ICEM] Problem making structural mesh on a surface	froztbear	ANSYS Meshing & Geometry	1	November 10, 2011 08:52
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11

June 9, 2015, 11:54		#2
Ollie West New Member Oliver Westbrook-Netheton Join Date: Jan 2014 Posts: 16 Rep Power: 12	Hi cinclus, It is possible to export meshes generated in ICEM to Star-CCM+. However with overset meshing you will have to be very careful that the boundary between the background mesh and overset mesh contain cells of approximately the same size. This could make generating efficient grids with inflation control in certain regions a problem if the overset were to move near them. Hope this helps. Ollie.