|
[Sponsors] |
[DesignModeler] Extend fluid volume 3D nozzle |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 10, 2015, 08:16 |
Extend fluid volume 3D nozzle
|
#1 |
New Member
Jacopo
Join Date: Jun 2015
Posts: 10
Rep Power: 10 |
Hi, I have a 3D nozzle (imported from a CAD) with BCs of pressure outlet, so I decided to extend the volume domain to avoid reverse flow at the outlet.
Since I am new in fluent, I am not very experienced with this practise.. What is the best way to do that? I mean, can I create it in designModeler or must I do it in my CAD software? should I do boolean operations on the two volumes before meshing? and where should I impose the boundary condition of pressure outlet? Thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
There is no fluid volume in the project | Giron | FloEFD, FloWorks & FloTHERM | 5 | December 30, 2022 08:58 |
Error message: Insufficient Catalogue Size | Paresh Jain | CFX | 32 | February 3, 2021 03:37 |
[DesignModeler] Creating Fluid Volume | willis | ANSYS Meshing & Geometry | 4 | February 24, 2012 00:15 |
compressible flow in a counterflow nozzle | d.vamsidhar | FLUENT | 0 | November 24, 2005 01:45 |
define the fluid volume | nessi benishti | FLUENT | 0 | August 2, 2005 16:57 |