|
[Sponsors] |
June 16, 2015, 04:32 |
Icem Cfd Association
|
#1 |
New Member
gautham narayan
Join Date: Apr 2015
Posts: 16
Rep Power: 11 |
I have a problem in ICEM cfd that I have been trying for almost 3 weeks now, without any success. It would be very helpful if someone can point out where I could be going wrong. i am attaching my a screenshot of the incorrect 2D mesh but it is hard to find out the mistake from it.
the mesh looks fine to me but when doing a mesh check it says, that there are overlapping elements, on viewing the subset it shows the overlapping elements highlighted, but on deleting them there is no other elements there. i understand that the icem thinks that there are two boundaries there, when actually there is only one. how do i correct this. i am attaching my geometry and blocking file if someone could help me out with where i am going wrong. thanks a lot |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Icem CFD on Linux | mechanicaldesign | ANSYS Meshing & Geometry | 7 | March 11, 2021 19:44 |
Need help icem cfd | kakhtar | ANSYS Meshing & Geometry | 25 | January 31, 2017 01:09 |
Transport mesh from ICEM CFD, to Fluent, to Sysnoise | Wieland | FLUENT | 2 | April 15, 2012 06:28 |
[ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent | ivanddd | ANSYS Meshing & Geometry | 1 | February 3, 2011 00:51 |
Which is better to develop in-house CFD code or to buy a available CFD package. | Tareq Al-shaalan | Main CFD Forum | 10 | June 12, 1999 23:27 |