 |
 |
 |
|
|
|
[Sponsors] | ||||
June 29, 2015, 07:12
|
ICEM - just mesh specific parts
|
#1 |
|
New Member
Join Date: Jun 2015
Posts: 2
Rep Power: 0  |
Hey everyone,
i try to mesh parts of a centrifugal compressor in ICEM. The parts that should be meshed are the Inlet, Centrifugal Diffusor, Volute and Outlet. I transfer the geometry data out of Design Modeller. I want to create seperate meshes for each part. The Inlet, Diffusor and Outlet are meshed with O-Grid,Hex so there you can decide with the Blocking which part should be meshed The Volute should be meshed with automatically with tetra. How can make a choice in ICEM that just Volute part should be meshed with tetra. |
|
|
|
|
|
June 30, 2015, 05:37
|
|
#2 |
|
New Member
Siddana ravi Kumar
Join Date: Apr 2015
Posts: 10
Rep Power: 11 |
can you provide geometry?
|
|
|
|
|
|
|
June 30, 2015, 08:35
|
|
#3 |
|
New Member
Join Date: Jun 2015
Posts: 2
Rep Power: 0 |
Hey no i'm sorry...it's not possible to upload the geometry.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] CGNS Mesh Importation into ICEM | huey1080 | ANSYS Meshing & Geometry | 5 | April 3, 2022 18:19 |
| ICEM of ANSYS V15: how to export .msh mesh for CFX | hydroaero | ANSYS | 1 | March 9, 2015 22:17 |
| ICEM of ANSYS V15: how to export .msh mesh for CFX | hydroaero | CFX | 1 | March 9, 2015 22:15 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
| ICEM 10 mesh question | DAK565656 | CFX | 6 | May 8, 2007 12:16 |
Linear Mode
