|
[Sponsors] |
[ANSYS Meshing] AQWA : Error with ratio of adjacent areas |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
July 22, 2015, 11:04 |
[Solved] AQWA : Error with ratio of adjacent areas
|
#1 |
New Member
Join Date: Jul 2015
Posts: 3
Rep Power: 10 |
Hi everyone,
I'm a beginner in Aqwa and i'm currently struggling with meshing a geometry. I have designed the geometry with Solidworks, generated a mesh in a Aqwa and tried to solve hydrodynamics to see if everything was okay. Aqwa reports the following error : ratio of the areas of adjacent elements must be less than 0.333. I tried to adjust element size and defeaturing tolerance of my mesh but couldn't find a solution. Where can I check the ratios of adjacent elements areas ? How to avoid this error message ? Regards, Antoine Edit : The solution seems to be quite simple, just check "YES" for "Ignore modelling rule violations" in "Analysis settings". I think this is called the GOON option, and with that the analysis runs normally. Last edited by antoinea; July 24, 2015 at 10:39. Reason: Problem solved |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with divergence | TDK | FLUENT | 13 | December 14, 2018 06:00 |
[ICEM] Error in Prism Ratio Computed | singer1812 | ANSYS Meshing & Geometry | 0 | September 22, 2011 16:29 |
pressure eq. "converges" after few time steps | maddalena | OpenFOAM Running, Solving & CFD | 69 | July 21, 2011 07:42 |
diesel spray combustion equivalence ratio | usker | Siemens | 12 | March 1, 2008 06:09 |
Problem of Turbulent Viscosity Ratio Limited | David Yang | FLUENT | 3 | June 3, 2002 06:13 |