[ICEM] Convertin an ICEM tin or tetin file in IGES or STEP

vangelis · September 17, 2015, 04:23

Hello

I would like to know if and how one can convert a tin or tetin ICEM file
into IGES or STEP geometry.

Is there any information or quality that will be lost in this translation?

Thanks,

Vangelis

attiquejavaid08 · September 17, 2015, 10:40

file > export geometry > to iges
it will ask for .tin file first. select it and next you can save it as iges

never did it before. so i'm not sure about any quality loss.

AJ

vangelis · September 18, 2015, 02:06

Thanks AJ

Any other option? Is there any ANSYS software, say Design Modeller
that can read tin files and save them as IGES or STEP?

September 17, 2015, 04:23	Convertin an ICEM tin or tetin file in IGES or STEP	#1
vangelis Senior Member Vangelis Skaperdas Join Date: Mar 2009 Location: Thessaloniki, Greece Posts: 287 Rep Power: 21	Hello I would like to know if and how one can convert a tin or tetin ICEM file into IGES or STEP geometry. Is there any information or quality that will be lost in this translation? Thanks, Vangelis

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[swak4Foam] funkyDoCalc with OF2.3 massflow	NiFl	OpenFOAM Community Contributions	14	November 25, 2020 03:30
SparceImage v1.7.x Issue on MAC OS X	rcarmi	OpenFOAM Installation	4	August 14, 2014 06:42
[swak4Foam] Swak4FOAM 0.2.3 / OF2.2.x installation error	FerdiFuchs	OpenFOAM Community Contributions	27	April 16, 2014 15:14
pisoFoam compiling error with OF 1.7.1 on MAC OSX	Greg Givogue	OpenFOAM Programming & Development	3	March 4, 2011 17:18
[blockMesh] Axisymmetrical mesh	Rasmus Gjesing (Gjesing)	OpenFOAM Meshing & Mesh Conversion	10	April 2, 2007 14:00

September 17, 2015, 10:40		#2
attiquejavaid08 Member Attique Javaid Join Date: Apr 2015 Location: Pakistan Posts: 66 Rep Power: 11	file > export geometry > to iges it will ask for .tin file first. select it and next you can save it as iges never did it before. so i'm not sure about any quality loss. AJ

September 18, 2015, 02:06		#3
vangelis Senior Member Vangelis Skaperdas Join Date: Mar 2009 Location: Thessaloniki, Greece Posts: 287 Rep Power: 21	Thanks AJ Any other option? Is there any ANSYS software, say Design Modeller that can read tin files and save them as IGES or STEP?