|
[Sponsors] |
[GAMBIT] ERROR:two geometrically coincident faces were detected |
![]() |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
![]() |
![]() |
#1 |
Member
misagh
Join Date: Apr 2012
Posts: 64
Rep Power: 14 ![]() |
Hi
I'm making a 3D mesh in Gambit. I faced with this error while attempting to create a volume through some stitches faces: two geometrically coincident faces were detected I don't know how to find these two faces? |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 ![]() |
I would try to move (not copy) one face anywhere, to see if if have any unconnected surface
__________________
In memory of my friend Hervé: CFD engineer & freerider ![]() |
|
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Decomposing meshes | Tobi | OpenFOAM Pre-Processing | 22 | February 24, 2023 09:23 |
Foam::error::PrintStack | almir | OpenFOAM Running, Solving & CFD | 91 | December 21, 2022 04:50 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 10:58 |
user subroutine error | CFDUSER | CFX | 2 | December 9, 2006 06:31 |