[ANSYS Meshing] Is it possible to extrude mesh ?

Onurozcan · December 7, 2015, 13:31

Hi,

First of all I wanna do inflation mesh in boundary layer ( tubes) in surface.But system I am working on is a body.Then the body will be extruded according to first surface mesh.

Is it possible to do that? and how could I do this?

Kapi · December 10, 2015, 21:51

you can just reverse your way, extrude first and then give your inflation and get similar mesh!

Onurozcan · December 12, 2015, 20:25

Quote:

Originally Posted by Kapi

you can just reverse your way, extrude first and then give your inflation and get similar mesh!

Thank you for replying message

Kapi you would like to mean that first extrude your geometry then initiate inflation mesh.

Thank you

December 7, 2015, 13:31	Is it possible to extrude mesh ?	#1
Onurozcan Member Onur Join Date: Sep 2015 Posts: 42 Rep Power: 10	Hi, First of all I wanna do inflation mesh in boundary layer ( tubes) in surface.But system I am working on is a body.Then the body will be extruded according to first surface mesh. Is it possible to do that? and how could I do this?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
sliding mesh problem in CFX	Saima	CFX	46	September 11, 2021 07:38
[ICEM] Extrude mesh	luissanchez	ANSYS Meshing & Geometry	2	June 25, 2013 08:22
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation	tommymoose	ANSYS Meshing & Geometry	48	April 15, 2013 04:24
[ICEM] issue occur after extrude 2D airfoil mesh and convergence problem in CFX	shiyun	ANSYS Meshing & Geometry	4	May 9, 2012 19:55
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere!	sc298	OpenFOAM Meshing & Mesh Conversion	2	March 27, 2011 21:11

December 10, 2015, 21:51		#2
Kapi Senior Member Join Date: Apr 2014 Location: Melbourne Posts: 584 Rep Power: 14	you can just reverse your way, extrude first and then give your inflation and get similar mesh!