|
[Sponsors] |
February 3, 2013, 13:38 |
Growth ratio ICEM
|
#1 |
New Member
Marijo
Join Date: Jan 2011
Posts: 12
Rep Power: 15 |
Hello,
How can I set a "real" growth ratio of, for example 20% growth, for hexa mesh in ICEM? If bigeometric bunching law is set, for a given initial height there is a range of number of elements that could be applied for the same growth ratio. In other words, there is no unique number of elements for a given growth ratio. Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Problem with divergence | TDK | FLUENT | 13 | December 14, 2018 06:00 |
[Commercial meshers] [fluent3DMeshToFoam] High aspect ratio cells found (mesh from ICEM) | alquimista | OpenFOAM Meshing & Mesh Conversion | 10 | January 29, 2013 15:28 |
[ICEM] How to show grids expansion ratio in ICEM | Anna Tian | ANSYS Meshing & Geometry | 5 | January 26, 2013 13:07 |
[ANSYS Meshing] Growth ratio with body sizing | saisanthoshm88 | ANSYS Meshing & Geometry | 1 | October 12, 2012 07:51 |
pressure eq. "converges" after few time steps | maddalena | OpenFOAM Running, Solving & CFD | 69 | July 21, 2011 07:42 |