|February 2, 2016, 02:58||
how to mesh 3d cuboid
Join Date: Feb 2016
Posts: 11Rep Power: 3
can somebody plz help??
1. how to mesh a 3-D cuboid in gambit??
problem is....should i go for 1. volume meshing?? OR
2. EDGE MESHING THEN FACE MESHING , THEN VOLUME MESHING??
I am terribly confused. will volume meshing perform edge meshing, face meshing by itself???
|February 2, 2016, 10:48||
Join Date: Mar 2009
Posts: 3,193Rep Power: 33
If you tried, you would have seen that a volume meshing will perform edge/surface meshing by itself
In memory of my friend Hervé: CFD engineer & freerider
|edge meshing, face meshing, volume meshing|
|Thread||Thread Starter||Forum||Replies||Last Post|
|Star CCM Overset Mesh Error (Rotating Turbine)||thezack||CD-adapco||7||October 12, 2016 11:14|
|[ICEM] surface mesh merging problem||everest||ANSYS Meshing & Geometry||44||April 14, 2016 06:41|
|decomposePar problem: Cell 0contains face labels out of range||vaina74||OpenFOAM Pre-Processing||27||November 2, 2015 18:04|
|sliding mesh problem in CFX||Saima||CFX||45||September 22, 2015 10:53|
|[ICEM] Problem making structural mesh on a surface||froztbear||ANSYS Meshing & Geometry||1||November 10, 2011 09:52|