|
[Sponsors] |
[Workbench] How to create solid cylinder with helical groove on its surface. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 26, 2016, 17:57 |
How to create solid cylinder with helical groove on its surface.
|
#1 |
New Member
Jenny Kapoor
Join Date: Apr 2016
Posts: 5
Rep Power: 10 |
Hello friends, I am trying to create a helically grooved cylindrical geometry in workbench for modeling a mechanical tool. The tool/geometry looks exactly like the picture in the link below
http://solidworksoven.com/2015/07/ho...olidworks.html It is possible to create this geometry in solidworks using helical sweep cut but I am not sure how to do it in Ansys. Could you all please guide me? Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Helical wire wrapped around cylinder blocking strategy in ICEM | wingcollide | Main CFD Forum | 6 | December 25, 2013 19:32 |
[GAMBIT] How to plot S pipe | mariam.sara | ANSYS Meshing & Geometry | 36 | November 7, 2013 15:22 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
solid edge problem....can you help? | cindy | Main CFD Forum | 3 | April 5, 2004 13:43 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |