|
[Sponsors] |
[ICEM] ICEM automatically merging two separte parts |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 9, 2016, 08:48 |
ICEM automatically merging two separte parts
|
#1 |
New Member
kasra
Join Date: Feb 2016
Posts: 5
Rep Power: 10 |
hi all
I have a model of an air to air heat exchanger. basically there are two air streams which are separated by a copper foil of 0.01mm thickness. when I mesh the geometry in ICEM the software automatically considers the copper foil to be part of the cold air stream. so because of this problem when I import the mesh into CFX it is not possible to specify boundaries for the copper sheet. any suggestion would be appreciated. thanks in advance |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
ICEM mesh merging problem | Serge | CFX | 2 | October 22, 2007 06:13 |
merging edges in ICEM | Virag Mishra | CFX | 4 | August 24, 2007 06:06 |
Merging mesh elements in ICEM | Felix | CFX | 1 | May 9, 2007 10:33 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |