|
[Sponsors] |
May 23, 2016, 07:26 |
Inflation at ANSYS Meshing
|
#1 |
New Member
Prasenjit Sanyal
Join Date: May 2016
Posts: 25
Rep Power: 9 |
Generally we use inflation around 4 faces of a building to give a smooth flow. But if there is a inner portion of building then can we also use inflation there?? Why not we provide inflation at top of a building ??
|
|
May 24, 2016, 01:16 |
|
#2 |
Senior Member
Join Date: May 2012
Location: Melbourne
Posts: 161
Rep Power: 13 |
geuess you have to work out, where it is important.
In a building? The boundary layer is pretty thin, is it necessary? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
[ANSYS Meshing] Inflation - Airfoil Meshing - Divergence problem | dalecooper | ANSYS Meshing & Geometry | 0 | July 19, 2013 07:04 |
[Other] Ansys meshing airfoil and / or compressor blades | baw192 | ANSYS Meshing & Geometry | 8 | September 23, 2011 00:43 |