 |
 |
 |
|
|
|
[Sponsors] | ||||
October 4, 2016, 00:26
|
Meshing in Icepak
|
#1 |
|
New Member
Nick
Join Date: Aug 2016
Posts: 1
Rep Power: 0  |
Hello Everyone
I am relatively new to Ansys Icepak and i am Having some problem in Meshing. my problem consist of two groups of six cylindrical primitives (3 in each group) one on top of other.this two groups are bounder by plate at top and bottom. my problem is i cant get a o grid generated for this primitives due to which the mesh quality is low. i tried making separate assemblies but even though it is not possible. also my mesh quality comes to 0.12 but it does not show any error. what can i do to improve my mesh size...??? also can you suggest some links with examples on elctronics cooling done on ansys Icepak Thanks in Advance...... 
|
|
|
|
|
| Tags |
| ansys icepak, meshing in 3d, o-grid generation |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] only automatic meshing works, | kazra | ANSYS Meshing & Geometry | 2 | February 23, 2017 11:38 |
| [Other] Need advice on meshing in Icepak | Antanas | ANSYS Meshing & Geometry | 1 | August 18, 2016 02:44 |
| [Gmsh] 3D coil mesh: can't create the volume? | RomainBou | OpenFOAM Meshing & Mesh Conversion | 3 | July 18, 2016 05:09 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
| Flotherm-Icepak comparison for electronic cooling | Masoud Ameli | FLUENT | 0 | February 28, 2005 09:00 |
Threaded Mode
