 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] problem about spliting a 2D face in ansys |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 29, 2016, 14:02
|
problem about spliting a 2D face in ansys
|
#1 |
|
New Member
da
Join Date: Oct 2016
Posts: 5
Rep Power: 9  |
Hi my friends
I designed a 2D square plate in ansys geometry. But I want to create a blade(2D curve) on this plate. I use a 2D curve but when I use face split option it splits all face along this curve. But I just want to a 2D curve between this plate with definite length. Because I want to use that as wall boundary condition in fluent. I attached my geometry. |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] Error in mesh writing | helios | ANSYS Meshing & Geometry | 21 | August 19, 2021 14:18 |
| Problem with 'Mapped Face Meshing' | RobertW | FLUENT | 0 | November 19, 2016 15:39 |
| [snappyHexMesh] SnappyHexMesh Parallel run - face ordering problem | DaveR | OpenFOAM Meshing & Mesh Conversion | 8 | November 9, 2016 10:53 |
| [ANSYS Meshing] ANSYS Meshing Problem | Saikat_FM | ANSYS Meshing & Geometry | 1 | September 15, 2016 02:25 |
| [blockMesh] BlockMesh FOAM warning | gaottino | OpenFOAM Meshing & Mesh Conversion | 7 | July 19, 2010 14:11 |
Linear Mode
