|
[Sponsors] |
December 26, 2016, 15:18 |
Meshing a 3 D room
|
#1 |
Member
Vish
Join Date: Dec 2016
Location: Purdue University, IN, USA.
Posts: 59
Rep Power: 13 |
Hi All
I am a newbie and still in learning phase of ICEM. I am trying to mesh a 3 D room with furniture in it. I have created a block enclosing the whole geometry and then divided the block to create new blocks which enclose the geometry. After that I have attached the edges of the new block- which enclose the furniture- with the curves of the furniture. But I have not attached the other internal edges. I have attached the external edges to the curves of the walls of the room as well. My problem is that when I pre-mesh, I get a surface mesh on the walls of the room and internal walls only, but do not get any 3D mesh inside the room- where the fluid (air ) will be. Could someone help me tide over the problem? As I said, I am still learning the software and my problem might seem a very rudimentary one to you. But trust me, even going through ICEM tutorials did not help me here Regards |
|
December 26, 2016, 21:38 |
|
#2 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
It does not show up by default . Octree genereates 3d mesh. Did you use octree
Sent from my Nexus 6P using CFD Online Forum mobile app |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Meshing cuboidal room with openings | nickdaish | ANSYS Meshing & Geometry | 6 | February 21, 2015 11:17 |
Meshing, Geometry and Particle Dispersion | nautVP | FLUENT | 1 | September 8, 2014 13:05 |
[ANSYS Meshing] Meshing strategy for External Flows | Hybrid | ANSYS Meshing & Geometry | 0 | January 24, 2012 14:27 |
Meshing 3D AHU room | khimkhim | ANSYS Meshing & Geometry | 3 | November 4, 2009 11:26 |
Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |