 |
 |
 |
|
|
|
[Sponsors] | ||||
[ANSYS Meshing] Two solids volume mesh fails...any idea why?? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 15, 2017, 18:53
|
Two solids volume mesh fails...any idea why??
|
#1 |
|
New Member
Join Date: Jul 2015
Posts: 12
Rep Power: 10  |
Hello again everyone
 I have a problem at the time of meshing a 2 solids volume. Volume 1 is inside volume 2 (volume 2 has a gap for volume 1, of course) When I try to mesh any of them, ansys meshing goes crazy and doesnt mesh correctly. However if I open any volume independently in a new meshing file,,,,it is meshed without any problem. I guess it may be any matching faces problem...but i dont know where to begin to solve this... any idea friends?? Thank you very much! 
|
|
|
|
|
|
May 16, 2017, 22:02
|
|
#2 |
|
Senior Member
Join Date: Apr 2014
Location: Melbourne
Posts: 584
Rep Power: 14 |
post geometry and error
|
|
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [blockMesh] Errors during blockMesh meshing | Madeleine P. Vincent | OpenFOAM Meshing & Mesh Conversion | 51 | May 30, 2016 10:51 |
| [snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
| [blockMesh] non-orthogonal faces and incorrect orientation? | nennbs | OpenFOAM Meshing & Mesh Conversion | 7 | April 17, 2013 05:42 |
| channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
| [snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Linear Mode
