|
[Sponsors] |
May 17, 2017, 07:20 |
Need help for 2D mesh interface problem
|
#1 |
New Member
Join Date: Mar 2017
Posts: 17
Rep Power: 9 |
Hi everyone,
I am another student novice in ICEM meshing. I am trying to mesh the geometry defined in the picture below. Everything went well for generating the mesh excepted that : - I defined the surfaces withe "Simple Surface Method From 2-4 Curves" and ICEM created additional lines to split the geometry in three different parts. - Once in Fluent those lines were named wall_fluid by the software and assigned as "wall". I changed the boundary type to "interface but impossible to set it as an interface (please see second figure below). Could anyone please help me, its quite urgent. Sorry for the terrible english. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Basic Nozzle-Expander Design | karmavatar | CFX | 20 | March 20, 2016 08:44 |
[mesh manipulation] Importing Multiple Meshes | thomasnwalshiii | OpenFOAM Meshing & Mesh Conversion | 18 | December 19, 2015 18:57 |
Sliding mesh interface - problem with velocities | Goodstuff | FLUENT | 1 | January 28, 2015 13:48 |
Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
Question about heat transfer coefficient setting for CFX | Anna Tian | CFX | 1 | June 16, 2013 06:28 |