[ANSYS Meshing] How to increase points on turbine blade (on 3D domain) -- CFD Online Discussion Forums

July 17, 2017, 16:49

How to increase points on turbine blade (on 3D domain)

rusham

New Member

Ruslan

Join Date: Dec 2016

Posts: 10

Rep Power: 9

Hello,

Can anyone help, how to increase the number of points on the wind turbine (as shown in below figure, so that mesh will be along turbine geometry?

Many thanks and best regards

Attached Images

	1.JPG (35.3 KB, 8 views)
	2.JPG (43.3 KB, 7 views)

July 21, 2017, 04:58		#2
vasava Senior Member Paritosh Vasava Join Date: Oct 2012 Location: Lappeenranta, Finland Posts: 732 Rep Power: 22	Select edge/face and impose sizing.

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Sudden increase the residual of Maxwell's equations	hsezsz	CFX	2	October 13, 2016 06:58
Rotating turbine blade	Pepe26	CFX	7	May 15, 2013 18:18
CFD for a turbine blade (literature)	stefanbj	Main CFD Forum	2	April 14, 2013 18:55
Wind Turbine Blade Geometry	SeanieB	Main CFD Forum	0	November 27, 2009 10:18
CEL insertion of points into domain?	Adrijana	CFX	1	December 7, 2006 07:48

All times are GMT -4. The time now is 23:03.