 |
 |
 |
|
|
|
[Sponsors] | ||||
September 29, 2017, 14:54
|
Meshing 2D rectangles.
|
#1 |
|
New Member
Lisa
Join Date: Apr 2017
Location: USA
Posts: 19
Rep Power: 9  |
Hi,
I was facing some challenges meshing a 2D geometry and wondering if there is GURU that can help me.  The geometry is\ basically 3 rectangles all of length 30m (30000mm). The widths are 150mm, 0.4mm and 0.2mm respectively. The problem is the meshing software is not putting any nodes on the smaller rectangles (i.e. 04mm and 0.2mm). I tried edge sizing functions to fix the number of divisions I get on these edges, however, it only works on the edge (i.e. I am unable to sweep these divisions along the length of the rectangle) as shown below in the image attached. Thanking you guys in anticipation |
|
|
|
|
| Tags |
| mesh 2d, meshing methods |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] only automatic meshing works, | kazra | ANSYS Meshing & Geometry | 2 | February 23, 2017 11:38 |
| [Gmsh] 3D coil mesh: can't create the volume? | RomainBou | OpenFOAM Meshing & Mesh Conversion | 3 | July 18, 2016 05:09 |
| [Gmsh] Vertex numbering is dense | KateEisenhower | OpenFOAM Meshing & Mesh Conversion | 7 | August 3, 2015 10:49 |
| [ANSYS Meshing] Icem meshing queries | Mfaizan | ANSYS Meshing & Geometry | 21 | July 30, 2015 23:10 |
Threaded Mode
