|
[Sponsors] |
[ANSYS Meshing] error:Zero or negative volume for elements. |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 27, 2017, 06:25 |
error:Zero or negative volume for elements.
|
#1 |
New Member
Join Date: Nov 2017
Posts: 19
Rep Power: 8 |
Hi everyone;
I’m getting “Zero or negative volume for element” error, while trying to create a very simple mesh in ANSYS 15.0, using workbench.It is a very simple model, just like a plate. One side is fixed ,the other is load.Give constant velocity to the model. the velocity up to 5 m/s.there is some information for the error.I don not know where is wrong with the model.the meshing?the analysis setting?or something else? The Quad Mesher failed on the following faces. License acquired! Checking model setup.....Please wait Generating External Edges ...... please wait Initializing.....Please wait Zero or negative element volume Zero or negative element volume Zero or negative element volume Zero or negative element volume Finished model setup with errors... I greatly appreciate any help or advice regarding my problem. Thank you. zhizhuo |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
[ICEM] negative sector volume | adam2008 | ANSYS Meshing & Geometry | 0 | August 9, 2014 00:24 |
[blockMesh] error message with modeling a cube with a hold at the center | hsingtzu | OpenFOAM Meshing & Mesh Conversion | 2 | March 14, 2012 09:56 |
remeshing due to negative volume error | Doginal | CFX | 1 | August 21, 2011 21:50 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |