|
[Sponsors] |
[ANSYS Meshing] (Sweep + Inflation) Corner Mesh Quality |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 7, 2018, 16:59 |
(Sweep + Inflation) Corner Mesh Quality
|
#1 |
New Member
Luiz Oliveira
Join Date: Aug 2018
Location: Napoli, Italy
Posts: 24
Rep Power: 8 |
Hello,
I am currently facing some difficulties in matching inflation layers. I can manage to create these layers but the elements that follows the region where these two meet have bad orthogonality quality. I think that forcing the layers to reach until the face will help forming better elements on the corners. Is there a way to force meshing into prolonging these layers? Please find some images attached. I tried meshing inflation from edge sizing before but it can't be done for all edges. Building multiple solids and matching the mesh didn't work also, as meshing fails to work in some of the "blocks". Thanks in advance |
|
Tags |
corner, inflation, orthogonality, sweep |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] What and how to use sweep mesh by inflating the boundaries? | alvinthum | ANSYS Meshing & Geometry | 2 | March 26, 2018 06:30 |
[snappyHexMesh] sHM layer process keeps getting killed | MBttR | OpenFOAM Meshing & Mesh Conversion | 4 | August 15, 2016 04:21 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 10:38 |
snappyhexmesh remove blockmesh geometry | philipp1 | OpenFOAM Running, Solving & CFD | 2 | December 12, 2014 11:58 |
How to control Minximum mesh space? | hung | FLUENT | 7 | April 18, 2005 10:38 |