[DesignModeler] Is exporting changed geometry. (divided lines) -- CFD Online Discussion Forums

November 28, 2018, 15:38	Is exporting changed geometry. (divided lines)	#1
sheaker Senior Member Oskar Join Date: Nov 2015 Location: Poland Posts: 184 Rep Power: 10	Dear Ansys users, I'm facing strange issue with DesignModeler and ANSYS Meshing tool. I prepared geometry for meshing purpose. Then I ran ANSYS Meshing and found that some single edges became divided. This is ruining my meshing procedure. Is there anything I can do? Best regards, Oskar __________________ How to set two stroke engine with scavenging? Salome, sliding interface and "Zero length edge detected."

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Tutorials] Tutorial of how to plot residuals !	wolle1982	OpenFOAM Community Contributions	171	February 20, 2024 02:55
Exporting geometry from Solidworks to ICEM!	Usman	CFX	1	November 27, 2007 16:20
Exporting geometry from Solidworks to ICEM!	Usman	Main CFD Forum	2	November 27, 2007 12:01
vitual _ real	deneb	FLUENT	3	January 22, 2007 04:31
Virtual/Real geometry.	Jack Keays	FLUENT	9	June 15, 2000 23:39

All times are GMT -4. The time now is 16:32.