|
[Sponsors] |
How to set two stroke engine with scavenging? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 2, 2017, 05:06 |
How to set two stroke engine with scavenging?
|
#1 |
Senior Member
Oskar
Join Date: Nov 2015
Location: Poland
Posts: 184
Rep Power: 10 |
Dear foamers.
I am very interested in simulation of two stroke engine with scavenging. There are presentations that I found about 2 stroke engines, done by Mr. Tommaso Lucchini: http://powerlab.fsb.hr/ped/kturbo/Op...2007Engine.pdf https://imem.cray.com/2013/Meeting-2...lia-Milano.pdf page 5. and another usage: http://publications.lib.chalmers.se/...ext/122640.pdf but none of them provide needed information for case setup. I have been trying to modify simpleEngineStem case for sonicTurbDymEngineFoam but I cannot make it run. If anyone of You could share a simple 2d case of two stroke engine with scavenging I would be gratefull. I wish You wonderful day! Sheaker PS. I still can't do sliding interface in 3d case: Salome, sliding interface and "Zero length edge detected." |
|
May 18, 2017, 14:02 |
Re: How to set two stroke engine with scavenging?
|
#2 |
New Member
Join Date: Dec 2012
Posts: 3
Rep Power: 13 |
Hi all,
I have the same question, would appreciate if someone could provide insights into setting up a two-stroke engine model in OpenFOAM. Regards, nimrod |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
guidance for scavenging process BC in internal combustion engine | immortality | Main CFD Forum | 1 | October 13, 2015 23:55 |
scavenging 2 stroke engine | dfreeman | FLUENT | 0 | May 3, 2013 09:29 |
4 stroke engine inlet/exhaust simulation | flo777 | CFX | 3 | March 16, 2010 16:44 |
Help with GNUPlot | Renato. | Main CFD Forum | 6 | June 6, 2007 19:51 |
modelling airflow through an inlet restrictor on a four stroke engine | mike ede | Main CFD Forum | 0 | October 8, 1999 09:06 |