|
[Sponsors] |
[ICEM] nodes of mesh are not coincident with nodes on edge |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 28, 2019, 15:41 |
nodes of mesh are not coincident with nodes on edge
|
#1 |
Senior Member
Weiqiang Liu
Join Date: Feb 2018
Posts: 278
Rep Power: 9 |
Hi all,
I am generating a mesh with ICEM. I first set parameters of node on edge like bunching ratio and node number. However, I found the nodes of mesh are not coincident with nodes I set on edge. I wonder why this happened. Can anybody help? Weiqiang |
|
May 3, 2019, 10:57 |
|
#3 |
Senior Member
Weiqiang Liu
Join Date: Feb 2018
Posts: 278
Rep Power: 9 |
Hi,
I solved the problem by meshing with structured mesh. Thanks for your concern! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] Creating multiple multiple cell zones with snappyHexMesh - a newbie in deep water! | divergence | OpenFOAM Meshing & Mesh Conversion | 0 | January 23, 2019 04:17 |
[ICEM] Mesh is leaking (hole) at trailing edge of wind turbine blade | Shahzad123 | ANSYS Meshing & Geometry | 5 | September 13, 2018 05:52 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
[snappyHexMesh] snappyHexMesh won't work - zeros everywhere! | sc298 | OpenFOAM Meshing & Mesh Conversion | 2 | March 27, 2011 21:11 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |