|
[Sponsors] |
[ICEM] 2D meshing of tandem cylinder in VIV for dynamic simulation |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 16, 2019, 06:50 |
2D meshing of tandem cylinder in VIV for dynamic simulation
|
#1 |
New Member
Mohamad Hamiddi
Join Date: May 2019
Posts: 1
Rep Power: 0 |
I have develop geometry and unstructured meshing of 2D model for tandem cylinder in VIV. The problem is, my meshing (line) around on the circle (represent the cylinder) and the wall_fluid (around cylinder) does not connected.
When i place the mesh into fluent for dynamic simulation, the cylinder break partially and cause error: Negative cell volume detected. How can i improve the meshing in order to have a proper part of cylinder and wall-fluid. When i use structured meshing, the mesh around cylinder and wall_fluid does not have this problem. But i still have the error: Negative cell volume detected and that's the reason i move to unstructured mesh. Please help me, i really need a clue on how to solve this. |
|
Tags |
cylinder, icem, meshing 2d, renewable energy, viv |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
"Frozen" dynamic meshing | maasyraf3 | OpenFOAM Pre-Processing | 0 | April 23, 2017 08:57 |
[ICEM] Meshing of a cylinder containing a small hole on one face | Giova82 | ANSYS Meshing & Geometry | 1 | August 12, 2015 07:49 |
Running a feedback control simulation of the flow around a cylinder | gasagna | OpenFOAM Running, Solving & CFD | 0 | July 16, 2014 11:03 |
[ANSYS Meshing] Meshing 3d circular cylinder in ICEM | darazsbence | ANSYS Meshing & Geometry | 0 | March 11, 2014 17:35 |
meshing on cylinder fails ICEM | potac | ANSYS Meshing & Geometry | 0 | October 25, 2011 06:21 |