|
[Sponsors] |
September 27, 2019, 05:24 |
Inflation
|
#1 |
Senior Member
Davide
Join Date: Jul 2015
Posts: 107
Rep Power: 10 |
Hi,
I'm imported a curve from file with Design modeller to create the profile of a car by point coordinate, in order to study its 2D flow-dynamic . Then I created as a sketch the external domain. When I want to create the mesh in Meshing I cannot create the inflation of the car but also in the other boundary. Why? Thanks |
|
October 14, 2019, 06:59 |
|
#2 |
Senior Member
Gwenael H.
Join Date: Mar 2011
Location: Switzerland
Posts: 392
Rep Power: 20 |
Hi Davide,
Could you give more details about the meshing method that you use (default, , tet, multizone, etc) as well as the inflation properties. A picture would help a lot |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Boundary Layer - Inflation Layer | dlkadk | FLUENT | 0 | September 16, 2017 11:11 |
[ANSYS Meshing] 3D Inflation mesh on an airfoil | kennyboy | ANSYS Meshing & Geometry | 1 | April 26, 2017 03:12 |
[ANSYS Meshing] Inflation Layers Being Finicky | Markua | ANSYS Meshing & Geometry | 12 | April 28, 2015 07:11 |
Fluent diverges when using inflation layers | ziggo | FLUENT | 4 | August 9, 2013 12:11 |
Large Valve Flow Analysis - Inflation Problem | sercan85 | ANSYS Meshing & Geometry | 2 | June 1, 2010 14:02 |