|
[Sponsors] |
March 17, 2020, 12:04 |
Learning Meshing
|
#1 |
New Member
Shivam gupta
Join Date: Jan 2020
Posts: 5
Rep Power: 6 |
How can I start learning 2D meshing and how can make sure that I have achieved minimum amount of discritozation error while meshing ? If there is any book or blog to which I can refer for the same?
|
|
March 17, 2020, 22:50 |
|
#2 |
Senior Member
Svetlana Tkachenko
Join Date: Oct 2013
Location: Australia, Sydney
Posts: 407
Rep Power: 14 |
Would suggest to look at these concepts
- mesh statistics (orthogonal quality, element skewness), - thickness of boundary layer - mesh convergence plot (H-plot) |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] only automatic meshing works, | kazra | ANSYS Meshing & Geometry | 2 | February 23, 2017 11:38 |
Problem with 'Mapped Face Meshing' | RobertW | FLUENT | 0 | November 19, 2016 15:39 |
[Gmsh] 3D coil mesh: can't create the volume? | RomainBou | OpenFOAM Meshing & Mesh Conversion | 3 | July 18, 2016 05:09 |
Meshing Process | sidharth9426 | STAR-CCM+ | 4 | September 15, 2015 03:31 |
[ANSYS Meshing] Meshing strategy for External Flows | Hybrid | ANSYS Meshing & Geometry | 0 | January 24, 2012 14:27 |