 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Create 3-D body out of surfaces |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
September 19, 2020, 12:34
|
Create 3-D body out of surfaces
|
#1 |
|
Senior Member
Syavash Asgari
Join Date: Apr 2010
Posts: 473
Rep Power: 18  |
Dear All,
I am new to Ansys Design Modeler (DM). I have imported a step file into DM from Catia. It is comprised of a closed outer domain and a airplane full model. However, DM only identifies surface bodies and not 3-D body. AFAIK, we need 3-D body for grid later in Ansys Meshing. I should mention that both plane and domain are enclosed surfaces. The question is, how can I generate a 3-D body using the existing surfaces, to create a symmetry plane in DM? I have realized that the symmetry command works on a 3-D body only. I would appreciate any help. Thanks, syavash |
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Create two regions based on surrounding surfaces | mschramm | OpenFOAM Pre-Processing | 0 | June 3, 2020 11:56 |
| [ANSYS Meshing] How to concentrate mesh on inner body surfaces | mariam.sara | ANSYS Meshing & Geometry | 0 | May 11, 2020 16:20 |
| how to create intersection line of two surfaces | lostking18 | CFX | 4 | March 9, 2020 01:11 |
| [DesignModeler] Urgent!!! how to create surfaces for flow inlet in a cylinder wall | C.C | ANSYS Meshing & Geometry | 0 | October 25, 2016 12:50 |
| [DesignModeler] How to create fluid body as I first designed the solid part through solid works? | rasekh64 | ANSYS Meshing & Geometry | 9 | May 13, 2013 13:15 |
Linear Mode
