|
[Sponsors] |
January 12, 2021, 12:33 |
Mesh folding in on itself
|
#1 |
New Member
Evan
Join Date: Jul 2020
Posts: 4
Rep Power: 6 |
I'm running into an issue where I set up the mesh and the CFX runs but when I run the turbo report in CFD-Post, the turbo initialization view shows that the mesh has been twisted and folded in on itself. What would I be doing wrong?
|
|
Tags |
ansys, ansys meshing, cfd-post |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] 2D hybrid mesh (unstructured mesh highly dependent on structured mesh parameters) | shubham jain | ANSYS Meshing & Geometry | 1 | April 10, 2017 06:03 |
[snappyHexMesh] Snappyhex mesh: poor inlet mesh | Swagga5aur | OpenFOAM Meshing & Mesh Conversion | 1 | December 3, 2016 17:59 |
[ICEM] Generating Mesh for STL Car in Windtunnel Simulation | tommymoose | ANSYS Meshing & Geometry | 48 | April 15, 2013 05:24 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 10:03 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 12:55 |