|
[Sponsors] |
April 3, 2021, 07:36 |
ICEM default stretching
|
#1 |
New Member
Join Date: Mar 2021
Posts: 13
Rep Power: 5 |
Hello,
I am having an issue regarding ICEM meshing. I am trying to mesh this far field boundary (images attached), but without the geometric stretching. I have applied the stretching to one end of the edge, but although I have 0m spacing on the side '1', it shows that there is some stretching. Any ideas? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Workbench] ICEM failing to update mesh in a Workbench flow project | VladCFD | ANSYS Meshing & Geometry | 7 | July 2, 2020 02:53 |
[ICEM] Cannot update new.3dm file in ICEM based on rpl file | jimmy871013 | ANSYS Meshing & Geometry | 3 | June 20, 2017 11:02 |
Cannot update new.3dm file in ICEM based on rpl file | jimmy871013 | Mesh Generation & Pre-Processing | 1 | June 20, 2017 02:21 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |