 |
 |
 |
|
|
|
[Sponsors] | ||||
[DesignModeler] Contact Region is found but it not suppose to touch? |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
November 4, 2022, 03:57
|
Contact Region is found but it not suppose to touch?
|
#1 |
|
New Member
sa
Join Date: Jun 2022
Posts: 13
Rep Power: 5  |
Good Evening, I was wondering, I used "Share Topology" in Design Modeler and in Meshing a contact region is automatically created. However there is two bodies not suppose to contact each other which is the Anode and Cathode/Channel-ca and also Anode/CC-Ca, Ca means Cathode and An means Anode.
But for Cathode/CC-An and Cathode/Channel-ca doesn't form any contact region. Does this mean I design the model in Design Modeler wrongly? |
|
|
|
|
|
| Tags |
| contact-region, design modeler tutorials, geometry ansys, meshing 3d |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| problem during mpi in server: expected Scalar, found on line 0 the word 'nan' | muth | OpenFOAM Running, Solving & CFD | 3 | August 27, 2018 05:18 |
| [Gmsh] Insatlling gmsh from the source code-issue? | CFD-Lover | OpenFOAM Meshing & Mesh Conversion | 20 | June 12, 2018 07:39 |
| Running UDF with Supercomputer | roi247 | FLUENT | 4 | October 15, 2015 14:41 |
| [Other] How to create an MRF zone ? | aminem | OpenFOAM Meshing & Mesh Conversion | 2 | December 8, 2014 11:45 |
| injection problem | Mark New | FLUENT | 0 | August 4, 2013 02:30 |
Linear Mode
