|
[Sponsors] |
November 9, 2022, 13:35 |
Problems with mesh/skew of a wing
|
#1 |
New Member
Geovane
Join Date: Jun 2022
Posts: 6
Rep Power: 3 |
Hello everyone!
I've been struggling with a problem with my mesh for a while and it's been impossible to find the source of it. Basically, I have the domain seen in the first two pictures, with an e. skew of 0.66 (which is not great, but adjustable). However, when I set the nodes to the lines at the extent of the wing (picture 3) the skew goes insanely low and it turns into a mess. I checked for any incorrect association but didn't find any. Does anyone may have an idea on what's going on? Any insights are welcome! Thanks! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] Front wing mesh problems | Emmanuel Biocca | ANSYS Meshing & Geometry | 0 | March 30, 2022 13:54 |
Wing FSI simulation: Shell elements or 3D solid body? | frossi | CFX | 3 | June 15, 2016 20:02 |
[ANSYS Meshing] Wing with winglet mesh problems | MAH_cape | ANSYS Meshing & Geometry | 1 | May 31, 2016 04:06 |
[snappyHexMesh] Problems with coarse/unsnapped cells in snappyHexMesh | scareneb | OpenFOAM Meshing & Mesh Conversion | 2 | August 13, 2014 07:13 |
[snappyHexMesh] Meshing 3D wing (hydrofoil) fails | klausb | OpenFOAM Meshing & Mesh Conversion | 0 | December 28, 2011 14:26 |