[BladeModeler] BladeGen problem in creating turbine blade -- CFD Online Discussion Forums

July 2, 2023, 12:33

BladeGen problem in creating turbine blade

aja1345

Senior Member

Aja

Join Date: Nov 2013

Posts: 496

Rep Power: 14

Hi friends
I have a problem to create a rotor geometry of an axial turbine. In fact, when i use from following path to shift model, geometry of blade changes. Why?
Tools>shift in z direction
Also, the pictures have attached.
Thanks a lot

Attached Images

	IMG_20230702_195353.jpg (95.7 KB, 14 views)
	IMG_20230702_195406.jpg (85.2 KB, 13 views)
	IMG_20230702_195416.jpg (64.6 KB, 9 views)
	IMG_20230702_195433.jpg (70.4 KB, 8 views)

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problem with torque output from a turbine simulation.	pa-dundas	FLUENT	5	July 17, 2022 05:27
Gas turbine blade cooling	Sagnik648	System Analysis	0	July 10, 2019 04:55
CFD_screening problem for Francis Turbine Optimization	berk can	Fidelity CFD	3	February 22, 2014 12:08
[ICEM] Problem with Y+ elements in 3D blade mesh	SlapGas	ANSYS Meshing & Geometry	12	September 12, 2013 11:40
[Other] ANSYS CFX-Meshing problem of a wind turbine blade	Zoe	ANSYS Meshing & Geometry	1	July 14, 2010 02:02

All times are GMT -4. The time now is 09:34.