|
[Sponsors] |
September 5, 2023, 11:20 |
How to create the mesh on curved surfaces
|
#1 |
New Member
Chang
Join Date: Sep 2023
Posts: 1
Rep Power: 0 |
Hello guys
I would like to create a model like this to study the crack propagation in ANSYS WB 2022R2. As you can see, the created mesh is fine (at least for me ) Then, I would like to introduce the side-groove parts to it, as shown below But I couldn't create a "working" mesh to these side-groove parts. I have tried many methods like splitting them into three parts (just like the first figure), patch conforming etc. So I would like to ask the opinions/suggestions from the experts (you guys) The .wbpz file is here! (the side-groove parts have been suppressed) https://drive.google.com/file/d/1Lss...ew?usp=sharing It would be much appreciated if you can help me solve the problem! Thanks in advance. |
|
Tags |
ansys, help in mesh, mesh 3d, workbench |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Foam::error::PrintStack | almir | OpenFOAM Running, Solving & CFD | 91 | December 21, 2022 04:50 |
[Other] splitMeshRegions does not create interface patch between regions | fsan | OpenFOAM Meshing & Mesh Conversion | 10 | June 6, 2022 05:56 |
[ICEM] How can I create prism mesh for a 3D domain surrounded by a torus? | lzgwhy | ANSYS Meshing & Geometry | 5 | May 18, 2017 17:10 |
[snappyHexMesh] Layers:problem with curvature | giulio.topazio | OpenFOAM Meshing & Mesh Conversion | 10 | August 22, 2012 09:03 |
Icemcfd 11: Loss of mesh from surface mesh option? | Joe | CFX | 2 | March 26, 2007 18:10 |